Assembly Instructions - Franke ZAQUA031 Notice De Montage Et De Mise En Service

7.

Assembly Instructions

7.1 Fasten the A3000 open electronic module drinking-water heater.
A: Actuator 1 (violet)
B: Actuator 2 (yellow)
C: Analogue output 0-10 V
D: Temperature sensor, cold water
E: Temperature sensor, hot water
F: Sensor connection 2/3
F: Sensor connection 1
H: Electrical T-junction, system lines (Power)
K: Electronic module
7.2 Connect the temperature sensor or an external measuring device with a floating output
contact (closer).
Connecting the temperature sensor
☞
To obtain an improved heat flow, it is recommended to place a few drops of heat transfer
compound (to be provided by the customer) on the
surface sensor
7.3
Place the
7.4 Place the soft-binder (c) around the
surface sensor
7.5 Connect the
(K), if necessary use the extension cable.
Connecting the adapter line
7.6 Cut off the brown and the green cores on the adapter line for the sensor connection 1.
7.7 Crimp the wire-end ferrule (e) on to the white and yellow cores of the actuator line.
7.8 Connect the adapter line for the sensor connection 1 to an external floating contact of a
measuring device, if necessary use an extension cable.
7.9
Connect the adapter line to the sensor connection 1 (G).
Connecting the actuators
7.10 Squeeze the wire-end ferrules (e) onto the actuator lines (d).
7.11 Connect the actuator lines to the actuators (e. g. solenoid valve).
Important!
Pin assignment table must be observed.
7.12 Connect the actuator lines (d) to the actuator distributor (L).
Electronic Distributor
module
violet
(b) on the pipeline (a).
(b) to the temperature sensor (E) of the electronic module
Output
violet 1_1
yellow 1_2
surface sensor
surface sensor
and the pipeline, and hook it in.
(b).
5