Control Panel - Avantgarde Elite Série Manuel D'utilisation

Lock and unlock the control panel
To lock the control panel simply press the pad (lock). If no pad is pressed within 1 minute then all
control pads will be automatically locked except the pad (lock), which can be used to unlock. To unlock,
press and hold the pad (lock) for 3 seconds until the indicator goes off.
Under locked condition, no pad pressing will function but the indicator will flash for 5 seconds to remind
you that the pad being pressed is locked
Temperature setting and display
• In normal condition, the temperature display indicates the current temperature of the
corresponding zone. During the setting operation, the temperature display flashes to remind you
that temperature setting are in process. To set the temperature in the upper zone press the
controls on the left side, for the lower zone those on the right side.
• The temperature in both upper zone and lower zone can be set separately. The temperature of
both zones can be set anywhere between 39°F to 61°F (4º to 16º).
• When the pad
decrease in an increment of one degree. If the pad
held for 2 seconds, the temperature displayed will increase or decrease in a speed of one
degree per half second.
• During the setting operation, the temperature displayed flashes until no pad is pressed within
approximately 3 seconds. Then your last setting is recorded and confirmed by that the display
stops flashing but to indicate instant temperature of that zone.
Note: The temperature display can be changed between Celsius and Fahrenheit by pressing
and holding both pads
approximately 3 seconds.
•
The zone temperature may have a difference of +/- 5°F (+/- 3ºC) from setting depending on
loading and ambient conditions.
•
The temperature display, indicator
symbol (left side) are for upper zone of the wine cooler.
•
The temperature display, indicator
symbol (right side) are for lower zone of the wine cooler.
•
The indicator
Indicators Lights
•
When it lights, the indicator
•
When it lights, the indicator
which can be used to unlock.
•
When it lights, the indicator
indicator will go off when the set temperature is met.
(warmer) or (colder) is pressed, the temperature displayed will increase or
(warmer) and
, control pads
, control pads
, and the control pads
indicates the unit is in the mode of "stand by".
indicates all control pads are locked except the pad
indicates the corresponding zone is in refrigeration cycle. The
(warmer) or
(colder) from the upper zone (left side) for
(warmer) and
(warmer) and
(lock) and (light) are for both zones.
(colder) is pressed and
(colder) near the
(colder) near the
(lock),