Before Using Your Appliance - Avantgarde Elite Série Manuel D'utilisation

SAVE THESE INSTRUCTIONS

BEFORE USING YOUR APPLIANCE

1.
Remove the exterior and interior packaging, including labels. If there are glue residue, rub
a small amount of mild liquid detergent with your fingers then rinse and wipe. Never use
sharp instrument, rubbing alcohol flammable fluids or abrasive cleaners, they could
damage the unit.
2.
Clean the wine cellar according to the instructions found in the "Cleaning" section of this
manual.
INSTALLATION
1.
This appliance is designed to be installed built-in or free standing.
2.
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
3.
Ambient temperature below 68°F (13°C) or above 90°F (32°C) will hinder the performance
of this appliance. This unit is not designed for use in humid location such as a garage or
for outside installation.
4.
Place the wine cellar on a flat, leveled, surface that is strong enough to support it once
fully loaded.
5.
Before connecting the appliance to the power source, let it stand upright for approximately
4 hours. This will reduce the possibility of a malfunction in the cooling system from
improper handling during transportation. Clean the inner surface with damp cloth. (please
refer to the cleaning section of this manual)
6.
To help with door closure position legs with a 1/8" tilt to the back.
7.
This unit is not designed to be installed in an RV or used with an inverter. Once the
appliance is plugged into a wall outlet, turn the unit on and allow the unit to cool down for
3-4 hours before placing wine bottles in the appliance. Commercial use will void the
warranty.