Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING YOUR APPLIANCE
Temperature Control and Display
1. When the unit is plugged in all of the display and indicators will light for 3 seconds and an audible
beep will be heard.
2. The temperatures in left zone and right zone can be independently controlled and displayed.
3. The temperature in either zone can be controlled between 39°F to 65°F (4°C to 18°C). (The zone
temperature may have a tolerance of +/-5°F (+/-3°C) from setting depending on different loading
and ambient conditions.)
Indicators Lights
•
When lit, the
adjustment can be made to that zone.
•
When lit, the
cycle (compressor is running). The
reached. Note: The
several minutes after the desired temperature is reached.
Lock and Unlock
The lock feature is designed to prevent the settings of your wine cooler from being adjusted
accidentally. In order to adjust any of the settings you must unlock the control panel by pressing the
"lock" pad for approximately 3 seconds. Once the unit is unlocked an audible beep will be heard and
the
"lock" indicator light will go out.
If no selection is made to adjust the unit in approximately one minute the control panel will
automatically return to the "lock" mode.
To lock the unit manually press the
Temperature setting
• Unlock the control panel by pressing the
panel is unlocked an audible beep will be heard and the
• Under normal conditions the temperature display indicates the current temperature of the
corresponding zone. When adjusting the temperature, the temperature display will flash to
indicate that the temperature is being adjusted.
• The temperature in both left zone and right zone can be set independently by pressing
(warmer) or
(colder) pads that correspond to desired zone. The temperature range of both
zones can be set between 39°F to 65°F (4°C to 18°C) +/- 5°F.
• When the pad
or decrease in an increment of one degree. If the pad
and held for 2 seconds, the temperature displayed will increase or decrease in a speed of one
degree per half second.
indicator light indicates that all of the control pads are locked and no
indicator light indicates that the corresponding zone is in the refrigeration
indicator will go off once the desired temperature is
light will remain on and the compressor may continue to run for
"lock" pad.
(warmer) or
(colder) is pressed, the temperature displayed will increase
pad for approximately 3 seconds. Once the control
indicator will go out.
(warmer) or
(colder) is pressed
16
Publicité
Chapitres
Table des Matières
