Care And Maintenance; Cleaning; Energy Saving Tips - Avantgarde LBWC-42SBS Manuel D'utilisation

Refroidisseur a vin/unite de breuvages encastrable
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CARE AND MAINTENANCE

Defrost
The ice build-up on the inner back wall during compressor operation will be automatically
defrosted in a compressor off cycle.
When defrosting is in process, the indicators
for both zones will run.
Each zone has its own drip pan placed at the bottom against rear wall. (See illustration on page
2.)
Defrost water will drain into the drip pans. Water accumulated in the drip pans should be
discarded periodically. It is recommended to empty the drip pans every second or third week.
(You will learn how often to empty the drip pans is practicable for your local climate.)
Cleaning Your Appliance
Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
Unplug the unit from the wall outlet.
Remove all contents.
Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution.
The solution should be about 2 tablespoons of baking soda to a quart of water.
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
The outside of the appliance should be cleaned with mild detergent and warm water.
Dry the interior and exterior with a soft cloth.
Dust or anything else blocking the vent may hinder the cooling efficiency of the appliance.
Vacuum the vent if necessary.
Vacation Time
Unplug the unit from the wall outlet.
Remove all the contents.
Clean the appliance.
Leave the door open slightly to avoid possible formation of condensation, mold, or odors.
Short vacations: Leave the appliance operating during vacations of less than three weeks.
Long vacations: If the appliance will not be used for several months, remove all content and
unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly, blocking it open if necessary.
Moving Your Appliance
Unplug the unit from the wall outlet.
Remove all the contents.
Securely tape down all loose items inside your appliance.
Tape the doors shut.

Energy Saving Tips

• The appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
Ensure that door is closed when the appliance is plugged in.
for both zones will go off, and the circulation fans
18

Publicité

Chapitres

Table des Matières
loading

Table des Matières