Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING YOUR APPLIANCE
The wine cellar should be placed where the ambient temperature is between 15 to 25 ºC. If the ambient
temperature is above or below this range, the performance of the unit may be affected. For example,
placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The zone
temperature may have a difference of +/- 5°F (+/- 3ºC) from setting depending on loading and
ambient conditions.
Recommended Temperatures for Chilling Wine
Red Wines:
15-18°C (58-65° F)
Dry/White Wines
9-15°C (48-58° F)
Sparkling Wines
5-9°C (40- 48° F)
TEMPERATURE CONTROL AND DISPLAY
The temperature range of the wine cooler is intended for 4° F to 18° F (+/- 5° F ).
The display usually shows the average temperature of the appliance at that moment.
PRE-SET WINE ZONES
Press the "RED" or "WHITE" pads to choose preset storage conditions for either red or white
•
wine. (The indicator light "RED" or "WHITE" will illuminate accordingly.)
The programmed temperature for red or white wine will be displayed for a few seconds.
•
MANUAL TEMPERATURE SETTING
The temperature of the wine cooler can be set anywhere between 39° F ~ 64° F (4°C ~ 18°C) by
•
pressing temperature up ▲ and temperature down ▼pads as follows:
1) Press the [SET] pad until you hear a "Beep" sound (approximately 2 seconds).
2) Press the ▲▼ pads to increase or decrease the desired temperature in increments of
one degree.
3) Press the [SET] pad to confirm your desired temperature setting. If no pad is pressed
within 10 seconds, your select temperature setting will be automatically confirmed.
NOTE:
To select temperature display between Celsius (°C) or Fahrenheit (°F), press the "▲" pad for
•
approximately 2 seconds.
The
indicator will remain ON during refrigeration cycle and will be OFF during idle cycle.
•
To switch the Interior light ON/OFF, press the
•
pad.
18
Publicité
Chapitres
Table des Matières
