Interior Light; Automatic Defrost - Avantgarde LBWC-52SE2 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ON/OFF SETTING:
The unit can be switched to "On" or "Off" mode by pressing [White] (▼) pad for approximately 2
seconds. When it is on, all the control and display work normally. When it is off, the unit does not
refrigerate and the control/display does not work with exception that the buzzer will beep if a control
pad is being pressed. Please remember that electric supply is still connected to the unit and its control
circuit when it is in "Off" mode.
NOTES:
If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before
restarting. If you attempt to restart before this interval the Wine Cooler will not start.
When you use the wine Cooler for the first time or restart the wine Cooler after having been
shut off for a long time, there could be a few degrees variance between the temperature you
select and the one indicated on the LED readout. This is normal and it is due to the length of
the activation time. Once the wine Cooler is running for a few hours everything will be back
to normal.
In humid weather, if your full loaded wine cooler is set at low temperature and the door
frequently opened, frost/ice may sometimes appear at lower part of the evaporator. This is
normal. To remove the frost/ice, please temporarily set your wine cooler at a higher
temperature for a few hours or switch off the power and open the door to accelerate.

INTERIOR LIGHT

You can turn the interior light ON or OFF by pressing the button marked with the "light" symbol.
If you would like to turn off the light just press the "light" button again.

AUTOMATIC DEFROST

There is no need for manual defrosting of this appliance due to automatic defrosting function.
The ice build-up on the inner back wall during compressor operation will be automatically
defrosted once the compressor cycle is off.
Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan
located above the compressor, from where it evaporates.
19

Publicité

Chapitres

Table des Matières
loading

Table des Matières