Interior Light - Avantgarde LBWC-26S Manuel D'utilisation

ON/OFF SETTING:
The unit can be switched to "On" or "Off" mode by pressing [White] (▼) pad for approximately 2 seconds.
When it is on, all the control and display work normally. When it is off, the unit does not refrigerate and the
control/display does not work with exception that the buzzer will beep if a control pad is being pressed.
Please remember that electric supply is still connected to the unit and its control circuit when it is in "Off"
mode.
NOTES:
If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before restarting. If
•
you attempt to restart before this interval the Wine Cooler will not start.
When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut off
•
for a long time, there could be a few degrees variance between the temperature you select and the
one indicated on the LED readout. This is normal and it is due to the length of the activation time.
Once the Wine Cooler is running for a few hours everything will be back to normal.
In humid weather, if your full loaded Wine cooler is set at low temperature and the door frequently
•
opened, frost/ice may sometimes appear at lower part of the evaporator. This is normal. To remove
the frost/ice, please temporarily set your Wine cooler at a higher temperature for a few hours or
switch off the power and open the door to accelerate.

INTERIOR LIGHT

You can turn the interior light ON or OFF by pressing the button marked with the "light" symbol. If you
would like to turn off the light just press the "light" button again.
5/12/2011
19