Layout And Storage - Avantgarde LBWC-26S Manuel D'utilisation

3-LAYOUT AND STORAGE

SHELVES
To remove a sliding shelf:
1. Remove all bottles from the rack.
2. Lift the rack upwards and then pull out.
3. To replace, put the sides of the rack back onto the supporting guides of the cabinet and push back
until the rack tabs snap into place.
Note: Make sure the tabs on the rack are well engaged in place before loading any bottles.
The units may contain up to 26 bottles:
There are five wine racks of full depth on upper part of the cabinet
•
to store 4 wine bottles
(Alternating front to back)
1 sliding shelf for (3 bottles facing the front)
•
The bottom rack of the unit contains 3 ( bottles facing the front)
•
All the top five wine racks have tabs to engage the cabinet on
•
both sides.
Any of the wine racks can be removed to store larger bottles.
•
RECOMMENDATIONS FOR LAYOUT AND STORAGE OF YOUR WINE CABINET
Your cabinet was designed to store a maximum number of bottles in total security. We
•
recommend that you observe the tips to optimize loading.
Spread your bottles out as evenly as possible over the shelves, so that weight is not
•
concentrated in one point; also make sure your bottles do not touch the back of the cabinet, or
the step at bottom.
Also make sure that bottles are not all grouped together at the top or bottom of the cabinet.
•
Observe the loading instructions provided in section 5, according to the type of storage fixtures
•
with which your cabinet is equipped, AND NEVER STACK BOTTLES ON A SLIDING SHELF.
Never try to pull out more than one sliding shelf at a time.
•
PLEASE NOTE
Before modifying your cabinet's original configuration in any way, be sure to ask your dealer for advice.
5/12/2011
17