Dentsply Sirona Lucitone Digital Print Mode D'emploi page 14

7. Use a Flocked Applicator Tip to apply a thin layer of
Lucitone Digital Fuse Step 3 - 3D Denture Sealer to
the repair area including around the margins and the
interproximal areas. (Figure 30)
8. Place the appliance repair side up in the inLab
Speedcure Processing Unit and select "Lucitone
Digital" and then "Repair." The program will run for 10
minutes followed by a 3-minute cool down. (Figure 31)
Note: Only cure one repair denture at a time. Only cure
one side of the arch.
9. Finish and polish the denture using conventional techniques.
CAUTION: Do not steam clean Lucitone Digital Print appliances.
J. Fracture Repair
Lucitone Digital Fuse™ Step 2 - 3D Denture Bonding Resin (1 of 2 Techniques)
1. Tack the fractured denture together using an adhesive glue
or sticky wax. (Figures 32A & B)
12
Figure 30
Figure 31
Figure 32A
Figure 32B