Replacing The Lamp; Closing The Door - AEG SKS91200F0 Notice D'utilisation

Problem
The compressor
does not start im-
mediately after
pressing the COOL-
MATIC switch, or af-
ter changing the
temperature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
Upper or lower
square is shown in
the temperature
Display.
dEMo appears on
the Display.
The buzzer sounds.
The Display is red.

6.1 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.

6.2 Closing the door

1. Clean the door gaskets.
Possible cause
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
The door is not closed
correctly.
2.
3.
Solution
The compressor starts after
a period of time.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start works
regularly.
Refer to "Door open
alarm".
If necessary, adjust the door. Refer
to "Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
25