Christopeit Sport RS 2 Notice De Montage Et D'utilisation page 21

Step 6:
Attach the pedal (27L+27R) at pedal crank (33L+33R).
1. Screw the right pedal (27R) into the locator in the right-hand side (as
seen in operation) for the pedal crank (33R) (Warning! the screw direction
is clockwise).
2. Screw the left pedal (27L) into the locator in the left-hand side (as seen
in operation) for the pedal crank (33L) (Warning! the screw direction is
anti-clockwise).
3. Then mount the pedal straps left and right on the associated pedals
(27). (The pedals are signed with "L" for Left and "R" for Right.)
Step7:
Attach the computer holder (32) at main frame (1).
1. Place the computer holder (32) against the main frame (1) and connect
the plug for the computer cable (31) with the matching plug for the
motor cable (28). Connect the plugs of pulse connection cables 3 (30)
with the matching plug of pulse connection cables 2 (26) too.
2. Push the computer holder (32) onto the locator provided for it at
the main frame (1). Ensure that the cable connections made are not
squashed. Screw the computer holder (32) onto the main frame (1) in
straight direction with screws (20), spring washers (42) and washers
(13).
Step 8:
Installation of the computer (44) at computer holder (32).
1. Put the plug of pulse connection cable 3 (30) and connection cable
(31) into the cable sockets from monitor (44)
2. Attach the monitor (44) to computer holder (32) and tighten with screws
(41) and washer (29). (Attention: Ensure that the cable loom are not
crunched or pinched during installation.)
21