Basic Scroll Saw Operation - Genesis GSS160 Manuel D'utilisation

OPErATiOn
ON/OFF Switch (FIG 10)
1. To turn the saw ON, move the switch (1) to
"ON" position.
2. To turn the saw Off, move the switch (1) to
"Off" position.
Variable Speed Dial (FIG 10)
your saw is equipped with a variable speed dial (2).
The blade stroke rate may be adjusted by simply
rotating the dial.
To increase speed, rotate dial (2) clockwise.
To reduce speed, rotate dial (2) counterclockwise.
NOTE: A hesitation before the blade movement after the saw is turned on is a normal condition of
this saw.
Dust Port (FIG 10)
your scroll saw has a 1-1/4" dust port (3) located at the front of the saw. The port can be connected to
a dust collection system.

Basic Scroll Saw Operation:

WArning:
saw before attempting to use the saw.
NOTE: Use scrap lumber to check the settings and to get the feel of operating
the saw before attempting regular work.
A scroll saw is basically a curve-cutting machine. It can also be used for straight cutting and beveling
or angle cutting operations.
for general type scroll cutting, follow the pattern lines by pushing and turning the work piece at the
same time. Do not try to turn the work piece while engaged in the blade without pushing it, the work
piece could bind or twist the blade.
GENERAL FREEHAND CUTTING
1. Lay out desired design, or secure design to the work piece.
2. Raise the blade drop foot by loosening the height lock knob.
3. Position the work piece against the blade and place the blade drop foot against the top surface of
the work piece.
4. Secure the blade drop foot by tightening the height lock knob.
5. Remove the work piece from the blade prior to turning the scroll saw ON.
WArning:
work piece.
WArning:
blade. The blade will deflect, reducing accuracy of cut, and may break.
6. Slowly feed the work piece into the blade by guiding and pressing the work piece down against the
table.
7. When the cut is complete, move the trailing edge of the work piece beyond the blade guard foot.
Turn the switch Off.
16" Variable Speed Scroll Saw
Operator's Manual
read and understand the following items about your scroll
never start the saw when the blade is in contact with the
Do not force the leading edge of the work piece into the
3
Fig 10
2
GSS160
1