GE GTE 17 Manuel D'utilisation Et D'installation page 20

2
REVERSING THE DOOR SWING
REHANGING THE DOORS
6
6.1 Rehang the fresh food door
6.1.1 Lower the fresh food door onto the
bottom hinge pin. Be sure the washer
is in place on the pin.
Plastic
Hinge
Washer
Bracket
Models with a hinge bracket
that has 2 screw holes.
6.1.2 Insert the pin on the center hinge into the
socket in the top of the door. Place the spacer,
then the washer, on the hinge pin. NOTE: The
center hinge must be turned over as shown when
mounted on the left side.
Hinge Pin
Plastic Washer
and Spacer
6.1.3 Tilt the door toward the cabinet. As the door is
brought into position, slide the hinge under the
head of the screw which earlier had been partly
driven into the outermost hole. Insert the
remaining screw, then tighten both screws
securely.
20
Installation Instructions
Plastic
Washer
Hinge
Bracket
Models with a hinge bracket
that has 4 screw holes.
(CONT.)
REHANGING THE DOORS
6
6.2 Rehang the frozen food
compartment door
6.2.1 Lower the freezer door onto the center hinge
pin. Be sure the washer and spacer are in place
on the pin.
Center Hinge Pin
6.2.2 Tilt the door toward the cabinet, lifting the top
hinge so the pin fits into the socket on the top
of the door.
6.2.3 Make sure the door is slightly above the top of
the cabinet and the gap between the doors is
even across the front. Tighten the top hinge
screws. Do not overtighten these screws—
tighten them until they are just snug, then turn
them another one-half turn.
(CONT.)
Plastic Washer
and Spacer