Reversing The Door Handles - GE GTE 17 Manuel D'utilisation Et D'installation

REVERSING THE HARDWARE
4
4.1 Remove the base grille (if your refrigerator has
one) by pulling it straight out.
4.2 Move the bottom hinge bracket and plastic washer
from the right side to the left side.
Plastic
Washer
Hinge
Bracket
Models with a hinge bracket
that has 2 screw holes.
4.3 Interchange hinge and screws at top right with
screws at top left of cabinet. Do not tighten screws
on hinge side at this time.
Installing the hinge on the left.
NOTES:
• Some hinges have four holes. Which holes you
use for installing the hinge depends on which
side you install the hinge.
• The outer edge of the hinge should be parallel
to the edge of the case for correct installation.
Installation Instructions
Plastic
Washer
Hinge
Bracket
Models with a hinge bracket
that has 4 screw holes.
Switch the hinge pin to the
opposite side of the bracket.
Installing the hinge on the right.

REVERSING THE DOOR HANDLES

5
5.1 Transfer fresh food door handle
5.1.1 Remove the bottom cap by pushing it toward
the bottom of the door, and remove the
screw underneath. Remove the two screws
holding the handle to the top of the door.
5.1.2 Remove the handle.
5.1.3 Remove the screws from the right edge of the
door top and insert them into the handle screw
holes on the opposite side.
Screws for
Handle Holes
Top
17