Master/Slave Mode; Operation With Remote Control - Velleman VDPLP64SLB Mode D'emploi

Stand-Alone Mode with Custom Static Colour
You can create a custom colour by adjusting the intensity of the red (r), green (g), blue (b), and amber (A)
LEDs.
To use a custom static colour:
1. Unplug any connection from the DMX input [5] of the device.
2. Press MENU until <U--> is displayed and press ENTER.
The last set colour value appears, for example <r100> = red LEDs intensity value = 100.
3. Use UP and DOWN to set the intensity (0–100) and press ENTER.
The next colour value appears.
4. Repeat for all colours until you have the desired output colour.
5. Press MENU to quit.
Stand-Alone Mode with Built-in Program
To set the device to stand-alone mode with a built-in program:
1. Unplug any connection from the DMX input [5] of the device.
2. Press MENU until <P--> is displayed and press ENTER.
3. Use UP and DOWN to select a built-in program:
<P1>: 4 colours switching
o
<P2>: 4 colours fading
o
<P3>: 15 colours switching
o
<P4>: 15 colours fading.
o
4. Press ENTER to confirm.
5. To set the speed of the program, press MENU until <S--> is displayed. Note: do not press ENTER.
6. Use UP and DOWN to set the speed from slow (1) to fast (100) and press ENTER to confirm.
7. Press MENU to quit.
Sound Activation
With sound activation, the LEDs respond to sound.
To use an automatic program with sound activation, proceed as follows:
1. Unplug any connection from the DMX input [5] of the device.
2. Press MENU until <P--> is displayed and press ENTER to confirm.
3. Use UP and DOWN to select the desired setting:
<P5>: 4 colours changing, responding to sound.
o
<P6>: 15 colours changing, responding to sound.
o
4. To change the sensitivity of the internal microphone, press MENU until <SenS> is displayed. Note: do not
press ENTER.
5. Use UP or DOWN to set the sensitivity from low (0) to high (100) and press ENTER to confirm.
6. Press MENU to quit.
9.

Master/Slave Mode

The master/slave mode allows for connecting several devices to a single master device in a daisy chain. All
slave devices will then work synchronously with the master device. The first device in the daisy chain functions
as the master device.
To set the devices to master/slave mode:
1. Unplug any connection from the DMX input [5] of the master device (the first device in the chain).
2. Connect the DMX input of the first slave device to the DMX output [6] of the master device.
3. Connect the DMX input of the subsequent slave devices to the DMX output of the previous slave device.
4. Set up the unit as described in Stand-Alone Mode.
5. On each slave device, set the DMX address to 1 as follows: press MENU until <8-CH> is displayed and press
ENTER.
6. Use UP and DOWN to set the DMX starting address to <d--1> and press ENTER.
10.

Operation with Remote Control

Note: Make sure to unplug any connection from the DMX input of the device if you want to use it in stand-alone
mode. A device in stand-alone mode may transmit DMX signals that could interfere with the DMX signals from
the controller.
V. 02 – 30/06/2014
VDPLP64SLB
6 ©Velleman nv