Using Special Nozzles - Dirt Devil Aqua clean Mode D'emploi

02_DD302_gb.book Seite 53 Freitag, 17. April 2015 1:44 01
7 Working with the hand-held steam cleaner

7.3 Using special nozzles

26
A
B
90°
C
27
A
B
28
A
B
NOTE:
All special nozzles can only be fitted to the previ-
ously installed pinpoint nozzle. All special nozzles are
attached in the same way.
1. Fit the pinpoint nozzle as described, Chapter 7.2, "At-
taching the pinpoint nozzle".
2. If the cleaning effect of the jet of steam alone is not suf-
ficient for your cleaning task, select a special nozzle:

The wire brush (Fig. 26/A) is used to remove particu-
larly stubborn soiling from non-delicate surfaces.

The plastic brushes(Fig. 26/B, large and small) are
used to remove heavy soiling from scratch-resistant surfac-
es.

The crevice brush (Fig. 26/C) works best for removing
dirt from between tiles and grooves.

The jet nozzle (Fig. 27/A) is recommended if the steam
jet has to be highly concentrated like for the pinpoint jet noz-
zle.

The spatula attachment (Fig. 27/B) is used to scrape
dirt from smooth surfaces which are not sensitive to
scratching.

The 2in1 combo attachment (Fig. 28/A) is used to
squeegee previously steamed glass surfaces. To do so, fol-
low the instructions in Chapter 7.4, "Steam-cleaning
90°
glass surfaces".

The 2in1 combo attachment (Fig. 28/B) with cotton
cover is used to freshen up upholstery and clothing. To do
so, follow the instructions in Chapter 7.5, "Freshening up
upholstery and clothing".
3. Slide the respective special nozzle onto the pinpoint jet
nozzle.
4. Secure the respective special nozzle by turning it 90° in
the direction of the arrow.
NOTE:
By turning is in the opposite direction you can release the
respective special nozzle again.
90°
53