Removing The Blades; Mounting The Loop Handle; Adjusting Trimmer For User; Adjusting Shaft Angle - Stihl FSA 45 Notice D'emploi

English
2
1
1
► Position the blade (1) on the mowing head so that the
bushing (2) locates in the large bore in the blade (1).
► Pull the blade (1) outwards until the bushing (2) engages
the small bore in the blade (1).
7.2.4

Removing the Blades

► Switch off the trimmer and remove the activation key.
30°
2
1
► Push the blade (1) inwards until the bushing (2) is
released from the small bore in the blade (1).
► Remove the blade (1) upwards.
7.3

Mounting the Loop Handle

► Switch off the trimmer and remove the activation key.
42
2
1
► Position the loop handle (2) so that the recess for the star
knob nut (1) is on the right – viewed from the control
handle.
► Ease the ends of the loop handle (2) apart and push it onto
the control handle until it engages in position.
► Insert the screw (3) through the hole.
► Fit the star knob nut (1) and tighten it down.
The loop handle (2) must not be removed again.

8 Adjusting Trimmer for User

8.1

Adjusting Shaft Angle

The shaft angle can be adjusted to suit the height and reach
of the user.
► Switch off the trimmer and remove the activation key.
B
C
D
8 Adjusting Trimmer for User
2
3
A
2
1
0458-718-9621-A