Motor Protection / Safety Device; Maintenance And Cleaning - IKA HS 260 basic Mode D'emploi

3106600c_HSKS260_052006:HS-KS 260 b-c 13.04.10 14:32 Seite 33
HS/KS260 0305
D-bushing plug (RS 232 C).
PC 1.5 Cable
This cable is required to connect the 7-pin connector to a PC (25-
pin connector).
PC 2.1 Cable
This cable is required to connect the 9-pin connector to a PC.
PC 1.2 Adaptor
This adaptor is required to connect the 9-pin connector to an 8-
way serial interface (25-pin plug).
AK 2.1 Cable
This cable is required to connect the 7-pin connector to a chart
recorder (4mm pin plug).
AK 2.2 Cable
This cable is required to connect the 15-pin connector to a chart
recorder (4mm pin plug).

Motor protection / safety device

If the motor is locked or if a load is placed on it resulting in a
higher temperature than is permitted, the device is turned off
automatically by the safety circuit and the control light flashes.
To eliminate the error, the weight of the material must be redu-
ced. Allow the device to cool off.
The device must be turned off and backon again.
The motor is turned off immediately in the event of a malfunc-
tion by a safety circuit. Amalfunction occurs if the safe and
secure functionality of the device cannot be guaranteed. A
malfunction is displayed for the Basic model by the red Off sig-
nal light coming on and flashing, and for the Control model by
the error message being shown on the display of the speed
indicator (see the section „Error Codes".

Maintenance and cleaning

The HS/KS260basic and HS/KS260control are maintenace-free. It
is subject only to the natural wear and tear of components and
their statistical failure rate.
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been clea-
ned and is free from any materials which may constitute a health
hazard. Use only cleansing agents which have been approved by
IKA to clean IKA devices. To remove use:
Dyes isopropyl alcohol
Construction materials water containing tenside / iso
propyl alcohol
Cosmetics water containing tenside / iso
propyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
For materials which are not listed, please request information
from IKA. Wear the proper protective gloves during cleaning of
the devices.
Electrical devices may not be placed in the cleansing agent for
the purpose of cleaning.
Before using another than the recommended method for clea-
ning or decontamination, the user must ascertain with the
manufacturer that this method does not destroy the instru-
ment.
33