Dometic TEC29EV Instructions De Montage page 25

TEC29EV
TEC29EV control panel (fig. c, page 9)
Item Description
1 Main switch
2 Motor connection
3 Remote control connection
4 Float connection (petrol tank)
5 12 V battery charger connection
6 Earth
7 230 V connection
8 Battery positive terminal
9 Cut-out switch
10.3 Connecting 230 V
A
NOTICE!
 Connect a relay or a switch to the vehicle's electrical system
so that the generator is not damaged when the external mains
is connected.
 Ensure that the electrical system is set up as follows:
– TN network:
The neutral conductor must be linked to the PE conductor
on the terminal via a jumper with a minimum diameter of
2.5 mm
sure that a safety switch (FI switch, 30 mA) and an in all-
pole overcurrent protection (e.g. circuit breaker, 13 A) are
installed.
– IT network:
Ensure that an insulation monitor and an in all-pole over-
current protection (e.g. circuit breaker, 13 A) are installed.
 Connect the generator so that it takes priority over the power
supply.
EN
Connecting the electrical power to the generator
2
. To protect against automatic shutdown, make
25