Low Battery Warning; Busy Channel Lockout (Bcl); Stun; Beginning / End Of Transmission (Tx) Signal - Kenwood TK-2160 Mode D'emploi

L B
OW ATTERY
Low Battery Warning alerts you when the battery needs to be
recharged or replaced. While transmitting or receiving, the
LED will blink red when the battery power is low. If
programmed by your dealer, a tone may also sound.
B C
USY HANNEL
When activated, BCL prevents you from interfering with other
parties who may be using the same channel that you
selected. Pressing the PTT switch while the channel is in use
will cause your transceiver to emit an alert tone and
transmission will be inhibited (you cannot transmit). Release
the PTT switch to stop the tone and return to receive mode.
S
TUN
When the transceiver receives a call containing a stun code,
either transmit mode will be disabled, or both receive mode
and transmit mode will be disabled (default). (This function is
used when a transceiver is stolen or lost.) Stun is cancelled
when the transceiver receives a call with a revive code.
B / E
EGINNING
The Beginning of TX and End of TX identification signals are
used to access and release some repeaters and telephone
systems.
If Beginning of TX is set, the ID signal is transmitted when you
press the PTT switch.
If End of TX is set, the ID signal is transmitted when you
release the PTT switch.
If both are set, the ID signal is transmitted when you press
and release the PTT switch.
W
ARNING
L (BCL)
OCKOUT
T
ND OF RANSMISSION
(TX) S
IGNAL
29