Monitor Unit (Parent Unit) - Philips SCD491 Mode D'emploi

Setting up for battery-operated use
When batteries are installed, you have an automatic back-up in
case of mains failure.
1 Remove the battery compartment cover (A-5).
2 Insert four 1.5V AA batteries, noting the + and –
configuration inside the battery compartment. Batteries are
not supplied, we recommend Philips alkaline batteries.
3 Close the battery compartment cover (A-5).
‹ The camera unit is now ready for battery-operated
use.

Monitor unit (parent unit)

The monitor unit can be mains- or battery-operated.When
batteries are installed, you have an automatic back-up in case of
mains failure.
Setting up for mains-operated use
1 Connect the power adapter cord to the unit power supply
jack (DC 8.0V - - < < + + - B-12).
2 Connect the AC power adapter (B-10) to a wall outlet.
Unwrap and fully extend the AC adapter cord.
‹ The camera unit is now ready for mains-operated
use.
Setting up for battery-operated use
1 Slide down the belt clip/support (B-15) and lift it up.
2 Remove the battery compartment cover (B-7) by sliding it
downwards.
3 Insert the five 1.2V AA rechargeable batteries supplied, noting
the + and – configuration inside the battery compartment.
Getting your baby cam ready
EN
9