Parkside PKGA 20-Li C2 Traduction Des Instructions D'origine page 34

GB IE
pull the sawblade out of the cut
until it has come to a standstill.
In­this­way­you­will­avoid­any­kickback­
and­can­safely­put­down­the­power­tool.
• Use only undamaged saw­
blades in perfect condition. Bent
or­blunt­blades­can­break,­adversely­
affect­the­cut­or­cause­kickback.
• Do not brake the sawblade af­
ter switching the appliance off
by applying side pressure. The
sawblade­may­be­damaged,­break­or­
cause­a­kickback.
Tighten the material firmly. Do
•
not support the workpiece by
hand or foot. Do not touch any
objects or the ground with the saw run-
ning.­There­is­a­risk­of­kickback.
• Hold the power tool tightly with
both hands while working and
ensure a secure footing. The
power­tool­is­guided­more­securely­
with both hands.
• Wait until the power tool has
stopped before placing it down.
The tool insert can tilt and lead to loss
of­control­over­the­power­tool.
• Switch the appliance off im­
mediately if the sawing blade
jams.­Spread­the­saw­cut­out­and­pull­
the blade out carefully. This can lead
to­loss­of­control­over­the­power­tool.
3) SPECIAL SAFETY INFORMATION
DURING SANDING AND
SCRAPING
• Only use the power tool for dry
sanding. Do not scrape moist
materials. Penetration of water into
the­power­tool­increases­the­risk­of­
electric­shock.
34
• Avoid overheating the sanded
object and the sander itself. Pos-
sible­fire­hazard.
• The workpiece gets hot dur­
ing grinding. Do not touch the
machined area, allow it to cool
down.­There­is­a­risk­of­burning.­Do­
not­use­coolants­or­the­like.­
• Always empty the dust con­
tainer before work breaks.
Sanding­dust­in­the­dust­sack,­micro­
filter,­paper­sack­(or­in­the­filter­sack­or­
extraction­system­filter)­can­self-ignite­
under unfavourable conditions such
as­flying­sparks­caused­by­grinding­
metals. Particular hazards are caused
if­the­sanding­dust­is­mixed­with­paint,­
polyurethane­residues­or­other­chemi-
cal substances, or if the sanded object
is­hot­after­long­working­periods.
4) SAFETY INFORMATION FOR
USING LONG DRILLS
a)­ Do not work at a speed higher
than the maximum permissible
speed for the drill.­Higher­speeds­
can cause the drill to bend slightly
when rotating freely without contact
with­the­workpiece­and­can­also­cause­
injury.
b)­ Always begin drilling at a low
speed and when the drill is in
contact with the workpiece.­Hig-
her­speeds­can­cause­the­drill­to­bend­
slightly when rotating freely without
contact­with­the­workpiece­and­can­
also cause injury.
c)­ Do not apply excessive pressu­
re to the drill. Drills can bend and
break­or­cause­a­loss­in­control,­thus­
resulting in injuries.