Technical Data - Topcom Butler 5500 Mode D'emploi

Topcom Butler 5500
11 GAMES
The Butler 5500 has 5 games:
• Press MENU then scroll to Games and press OK.
• Select a game and press OK. Press START to display the game menu which includes instructions.
• Press BACK to exit.
12 TROUBLESHOOTING
Symptom
No display
No tone
The icon flashes
Base or handset do not ring
Tone is good, but there is no
communication
Not possible to transfer a call on PABX
Telephone does not react to pressing the
keys

13 TECHNICAL DATA

• Standard:
• Frequency range:
• Number of channels:
• Modulation:
• Speech coding:
• Emission power:
• Range:
• Numbr of handsets:
• Powersupply base
• Handset Batteries:
• Handset autonomy:
• Talk time:
• Charging time:
• Normal conditions of use:
• Dialling mode:
• Flash time
Topcom Butler 5500
Possible cause
Batteries uncharged
Handset turned OFF
Telephone cord badly connected
The line is occupied by another handset
Handset out of range
The base has no power supply
The handset is not registered on the
base
The ringing volume is zero or low
The dialling mode is wrong
The FLASH time is too short
Manipulation error
DECT (Digital Enhanced Cordless Telecommunications)GAP (Generic
Access Profile)
1880 MHZ to 1900 MHz
120 duplex channels
GFSK
32 kbit/s
10 mW (average power per channel)
300 m in open space /50 m maximum inhouse
Up to 5
230V / 50 Hz / 35 mA 6,5V DC 180mA & 150mA Model: SD35-405
2 rechargeable batteries AAA, NiMh 750mAh 1,2V
100 hours in standby
10 hours
6-8 hours
+5 ˚C to +45 ˚C
Pulse / Tone
100 or 250 ms
Solution
Check the position of the batteries
Recharge the batteries
Turn ON the handset
Check the telephone cord connection
Wait until the other handset hangs up
Bring the handset closer to the base
Check the mains connection to the base
Register the handset on the base
Adjust the ringing volume
Adjust the dialling mode (pulse/tone)
Set the unit to Long Flash time
Remove the batteries and put them back
in place
23