Description; Operation - Dustcontrol DC 5800i 9.2 kW S Notice Originale

Description

Th e DC 5800i 9.2 kW S is stable, tough and reliable and
particularly suited to spot extraction in many diff erent
applications ie grinding, sanding and cleanup. With a very
low sound level, the DC 5800i 9.2 kW S is suitable for use
in areas which are sensitive to noise. Th e DC 5800i 9.2 kW
S is driven by a 3-phase, turbo pump.
Th e DC 5800i 9.2 kW S is driven by a two stage connected
turbopump with extremely high vacuum eff ekt. Th e machi-
ne is intended for use on material transportation systems or
for cleaning of abnormally heavy material. With theese types
of systems it is recommended to use a preseparator.
Th e high vacuum eff ect can also be used in conven-tional
systems where extra long hose or pipe systems are required.
Filter cleaning is done with reverse pulse which gives excel-
lent fi lter economy.
Material which has been extracted and separated is collected
in a 30 l container. Th e container can be removed with a
simple hand grip. Th e container can be moved using a pallet
truck. Th e collected material is easily handled in this way

Operation

Connect the machine to a suitable power source according
to the specifi cations found on the identi-fi cation label on
the machine. If an extension cord is to be used with the
unit, it should be suitably rated according to the prevailing
electrical code and be at least water resistant. Check rotation
of the motor at startup. On machines equipped with a phase
reverser, incorrect rotation can be easily changed. Machines
not equipped with a phase reverser will require the service
of a qualifi ed electrician to interchange two phases in the
power supply.
Th e fi lter should be cleaned 1-2 times per day with conti-
nuous running or if the machine is equipped with a fi lter
monitor, when this is in the red area.
For fi lter cleaning:
1. Start the machine.
2010-02-17
for disposal or recycling.
Th e DC 5800i 9.2 kW S is equipped with wheels and is
therefore easily moved. For transportation over longer dis-
tances, the DC 5800i 9.2 kW S can be moved with forklift
or pallet truck.
2. Close the shutter valve on the machines inlet.
3. With slow, even motion open the pulse top by lifting
the handle. Repeat three to six times.
4. Open the shutter valve.
5. If the fi lter condition meter reads green work can con-
tinue, if in the red, pulse clean again. If after several
repetitions, the fi lter condition still shows red the fi ne
fi lter must be changed.
DC 5800i 9.2 kW S - 9 Part No 9445