Accessories - Bosch ART 23 G Instructions D'emploi

EURO • Printed in England • BA F 016 L69 858 • ART 23/25 • GB • OSW 07/01
F016 L69 858.book Seite 5 Freitag, 6. Juli 2001 11:50 11
Cut off approx. 8 m line from the refill roll. Press one
end into the notch of the spool so that it stands out
approx. 4 mm.
Wind on the line tightly and in orderly layers in arrow
direction.
Thread the line's end through the slot in the cover
ring 20 from the inside.
Keep the line tight and slide the cover ring 20 over
the smaller diameter of the spool.
Build in the spool as described above.
If the trimmer should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number from the
nameplate of the machine!
Refilling Line
I2
(Model ART 25 GSA/GSAV/ERGOPOWER)
Take out the spool 18 as described above.
Remove the guide ring 20 as shown in figure I2
Cut off approx. 8 m line from the refill roll. Press one
end into the notch of the spool so that it stands out
approx. 4 mm.
Wind on the line tightly and in orderly layers in arrow
direction.
Keep the line tight and slide the cover ring 20 over
the smaller diameter of the spool.
Build in the spool as described above.
17 • F016 L69 858 • 07.01

Accessories

Line spool
ART 23 G
ART 23 GF/GFS/GFSV
ART 25 GSA/GSAV/ERGOPOWER F 016 800 050
Line refill (24 m)
ART 23 G/GF/GFS/GFSV (1.4 mm) F 016 800 003
ART 25 GSA/GSAV/ERGOPOWER
(1.6 mm)
After Trimming/Storage
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially
from the ventilation slots 7.
Turn the machine on its side and clean the cutting
guard 8 inside. If grass cuttings are compacted, re-
move with a wooden or plastic implement.
English - 5
F 016 800 001
F 016 800 002
F 016 800 052