EMAK EF 95 Manuel D'utilisation Et D'entretien page 61

towing an accessory must be lower
than the maximum speed of the
machine without towed accessories.
12. F o l l o w t h e i n s t r u c t i o n s f o r
maintenance and lubrication of towed
accessories as described in this
manual, to ensure their optimum
operation during work.
Mounting
For mounting see the relative trailer
manual.
Use
Also refer to the manual supplied with
the towed accessory.
WARNING
- To prevent possible injuries, before
fitting or detaching a towed accessory
from the machine, make sure there are
no bystanders in the vicinity. The same
applies when working.
- Accessories must only be towed, never
pushed.
- Do not exceed the recommended
transport capacities: the maximum
loads are 50 kg for the trailer.
- For better use of towed accessories,
distribute the load evenly over the
t r a i l e r 's t i p p e r b o d y o r i n t h e
spreader's hopper. An excessive rear
load increases the risk of overturning.
- To attach the trailer using the towing
hitch, bring the end part of the frame on
the accessory into contact with the hitch
on the machine, insert the pin in the
two holes on the base and lock in place
with the cotter pin.
- Do some trial runs to get accustomed to
driving the machine with unladen
towed accessories. Ascertain carefully
what speed you can work at and the
stopping times of the machine with
accessories hitched. Also bear in mind
that, with a fully laden trailer hitched to
the machine, the working conditions are
much more demanding.
Trailer
To unload material from the trailer's tipper
body, remove the cotter pin and the pin
that keep the body fixed to the frame. When
removing the pin, keep the tipper body
handle pressed with your other hand to
prevent the body from tipping up suddenly.
Then pull the handle upward to unload the
material. NOTE: The handle is extractable to
reduce the effort needed for lifting. After
emptying, push the handle down and lock
the tipper body in place by reinserting the
pin and cotter pin.
WARNING
- B e f o r e c a r r y i n g o u t u n l o a d i n g
operations, always ensure that there
are no people, animals or objects in
the vicinity of the trailer.
- Dimensions: 112x85x28 cm.
Maintenance
- Before or after a long period of storage,
use automotive oil to lubricate the
retaining hook on the tipper body, the
locking pin on the retaining hook and
the part of the frame with the two holes
for fixing the machine's towing hitch and
corresponding pin.
- Periodically grease or oil the wheel
bearings. Use grease for wheel bearings
or automotive oil.
- Periodically check the tightness of all
screws, nuts and bolts.
- Always keep the tyres sufficiently
inflated. Never exceed the maximum
recommended pressure. Incorrectly
inflated tyres (for example inflated to
different pressures) may cause loss of
balance.
2) Stone-guard kit
For use in place of the grass-catcher, when
the cuttings are not to be collected.
3) Snow blade
4) Flange connection snow blade
5) Snow chains
6) Lawn roller
7) Kits for electric drives bag emptying
(standard on 125 model)
NOTE: The electrical system control for
emptying bag is standard on all
tractors.
GB
61