Remote Control - Sony HT-S350 Mode D'emploi

 Bring the BLUETOOTH device close to
the Bar Speaker.
 Pair the Sound Bar and the
BLUETOOTH device again. You may
need to cancel the pairing with the
Sound Bar using your BLUETOOTH
device first.
 If the BLUETOOTH function is set to
off, set it to on (page 23).
Pairing cannot be achieved.
 Bring the BLUETOOTH device close to
the Bar Speaker.
 Make sure the Sound Bar is not
receiving interference from a wireless
LAN device, other 2.4 GHz wireless
devices, or a microwave oven. If a
device that generates
electromagnetic radiation is nearby,
move the device away from the
Sound Bar.
 Pairing may not be possible if other
BLUETOOTH devices are present
around the Sound Bar. In this case,
turn off the other BLUETOOTH
devices.
Sound of the connected
BLUETOOTH mobile device is not
output from the Sound Bar.
 Make sure that the BLUETOOTH
indicator on the Bar Speaker is lit
(page 6).
 Bring the BLUETOOTH device close to
the Bar Speaker.
 If a device that generates
electromagnetic radiation, such as a
wireless LAN device, other
BLUETOOTH devices, or a microwave
oven is nearby, move the device away
from the Sound Bar.
 Remove any obstacle between the
Bar Speaker and the BLUETOOTH
device or move the Bar Speaker away
from the obstacle.
 If the Bar Speaker is installed under
the TV, move the Bar Speaker away
from the TV.
 Reposition the connected
BLUETOOTH device.
 Switch the wireless LAN frequency of
any nearby wireless LAN router or PC
to 5 GHz range.
 Increase the volume on the
connected BLUETOOTH device.
The sound is not in sync with the
image.
 When you are watching movies, you
may hear the sound with a slight
delay from the image.

Remote Control

The remote control of the Sound Bar
does not function.
 Point the remote control at the
remote control sensor on the Bar
Speaker (page 6).
 Remove any obstacles in the path
between the remote control and the
Sound Bar.
 Replace both batteries in the remote
control with new ones, if they are
weak.
 Make sure you are pressing the
correct button on the remote control
(page 11).
The TV remote control does not
work.
 Install the Bar Speaker so that it does
not obstruct the remote control
sensor of the TV.
 This problem might be solved by
enabling the IR repeater function
(page 17).
Others
The Control for HDMI function does
not work properly.
 Check the connection with the Sound
Bar (refer to the supplied Startup
Guide).
GB
31