AEG 88032K-IN Notice D'utilisation page 37

Sticking the seal to the rabbet
• Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive sealing tape supplied onto the upper surface of the
rabbet along the edges of the cut-out section.
• Cut the sealing tape into four pieces relating to the length of the edges of the rabbet.
• For the four corners of the rabbet the ends of the sealing tapes must be cut into mitres.
Do not stick the ends over one another.
• Stick the sealing tape flush into the corner of the rabbet, so that no silicon compound
can get under the glass ceramic when grouting.
• Don't stretch the tapes when sticking them on.
Assembly
R10
R5
12
7
490
514 +1
min. 600
750
774 +1
min. 38
min. 5
Safety information
min. 500
min. 5
min. 20
37
min.
50
min. 25
min. 5