AEG 88032K-IN Notice D'utilisation page 34

34
What to do if ...
Problem/Display
Display is switching between
two heat settings
The residual heat indicator is
not displaying anything
lights up
lights up or
is displayed and
up
and number are displayed
Acoustic signal sounds when
appliance is switched off
Repeated acoustic signal (6x),
appliance switches off
Possible Cause
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch-off has been
triggered
There is water on the control
panel or the control panel is
covered with fat splashes
STOP+GO is activated
Power management is reduc-
ing the power of this cooking
zone
The cooking zone was only on
for a short time and is therefore
not hot
Unsuitable cookware
No cookware on the cooking
zone
Diameter of the base of the
cookware is too small for the
cooking zone
The cooking surface automati-
cally switches itself off (see the
lights
section "Automatic switch
off"); overheating e.g. when a
pot boils dry
Electronics fault
The control panel is wholly or
partly covered by objects.
One or more sensor fields have
been covered for longer than
10 seconds
Remedy
Deactivate child safety device
(see the section "Child safety
device")
Only touch one sensor field
Remove any objects (pans, etc.)
that are lying on the control
panel. Switch appliance on
again
Wipe the control panel
Switch off STOP+GO
See the section "Switching the
power function on and off"
If the cooking zone is supposed
to be hot, call your local Service
Force Centre.
Use suitable cookware
Put cookware on zone
Move to smaller cooking zone
Use suitable cookware
Switch appliance off. Remove
hot pot. Wait approx. 30 secs.
Switch appliance on again.
should disappear,
stay
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system) If
after switching on again,
displayed again, call the cus-
tomer service department
Remove objects.
Uncover sensor field
can
is