Aria 1.0 Mg Manuel D'utilisation page 65

1. When using both front and rear belts of the 4-point securement system, fix the wheelchair to the snap-hooks
assembled in the vehicle. Refer to the User Manual provided with the 4-point securement system.
Anchoring positions for the front belts
1. Fix the front belts onto the wheel stands.
2. Fasten the front belts to the snap-hooks system according to the instructions suggested by the safety belt
supplier.
3. Release the parking brakes and fix the front tensioning belts pulling the wheelchair backwards.
4. Reactivate the parking brakes.
Anchoring positions for the snap-hooks at the rear
1. Fix the snap-hooks to the carbon fibre axle.
2. Fix the rear belts to the sideboard system according to the instructions suggested by the securement belt
supplier.
3. Tighten the belts.
Adjustment of the posture support belt
1. Adjust the posture maintenance belt so that it adapts to the wheelchair user.
IMPORTANT!
Make sure the snap-hooks are covered by non-slip material in order to avoid side
sliding of the axle.
IMPORTANT!
Check that the pivots are completely inserted on both sides and placed in the
same position as the sideboard section. Make sure that inclination between the
snap-hooks and the belts is between 40° and 45°.
CAUTION!
The posture support belt must be used in addition, but it can never replace a
homologated safety system for passengers (3-point belt).
65 ENG