Elem Garden Technic SEBRTH18VLI Traduction Des Instructions D'origine page 52

Starting and stopping the prunner
1>To start the tool: press the lock button (6) and then press the trigger (24). Release the lock button once the
motor has started.
2> To stop the trimmer: Release the trigger.
3>Rotate this handle joint(36),you can take off the handle.
4>Push the button(34),you can make the handle up and down.
5>Push the battery lock button (39) can take the battery out
WARNING:
Do not connect to power supply until assembly is complete, Failure to comply could result in accidental starting and
possible serious personal injury.
Changing of the Saw Chain
ATTENTION: Always pull the power plug before undertaking any maintenance work.
The saw chain is full of sharp edges. When handling it you should always wear gloves.
1>Slacken the chain until it hangs loose by inserting the included combination tool into the head screw of
the chain tensioner.
2> Turn the screw counter-clockwise until the chain is very loose.
3>Next dismount the black plastic cover. Unscrew the hex nut (22),and take out the spring washer(23).
Take off the plastic cover(3) and lift chain and guide bar off the unit. After dismounting guide bar and chain lift
the chain off the guide bar and set it aside.
Improtant Notes: Clean oil and saw dust out of the area under the plastic cover with a brush of
blow it out with compressed air. Be especially sure to clean out the oil duct.
Clean the groove of the guide bar with a suitable tool of blow it out with compressed air. Take special
care to clean the oil ducts in the guide bar. Inspect the chain guides for wear and if necessary carefully smooth
them with a file and emery cloth. If the guide bar is at some point worn beyond repair it must be replaced with a
new one. Guide bars can be ordered from the Herstella
Page 52 de 64
Oil Duct
Chain Tensioner