Specific Safety Rules - Elem Garden Technic SEBRTH18VLI Traduction Des Instructions D'origine

14. Inspect unit before each use for loose fasteners, damaged or missing parts. Correct before using the
edger attachment. Failure to do so can cause serious injury.
15. Use only original manufacturer's replacement parts. Failure to do so, may cause poor performance,
possible injury, and your warranty.
16. Do not, under any circumstance ,use any attachment or accessory on this product , which was not
provided with the product ,or identified as appropriate for use with this product in the operator's manual.
17. Do not handle the product with wet hands.
18. Do not use the product if the switch does not turn the product on or off. A product that cannot be controlled
with the switch is dangerous and must be repaired.
19. Avoid accidental starting; never carry the product with your finger on the trigger.
20. Use common sense when using this product. Stay alert and pay attention to what you are doing.
21. Do not force the product. It will do a better job with less likelihood of a risk of injury when you operate it at
the rate for which it was designed.
22. Pull the plug out immediately if the mains or extension lead is damaged or severed.
23. Disconnect the product from the power supply when it is not in use, before servicing and when changing
accessories.

SPECIFIC SAFETY RULES

For Prunner.
This Prunner is a rugged, powerful device, but you should nevertheless note a few words of advice.
Always make sure that there is enough oil in the oil tank.
The Chain should always be well-oiled, if necessary soak the chain in bio-degradable chainsaw oil
before starting work. You can purchase chainsaw oil based on caster oil from the Hersteller in
quantities of 1 litre or 5 litres. While using the Prunner make sure that the chain is always well-soaked
in oil. If this is not the case manually oil the chain.
Make sure that the oil level does not drop under the minimum mark. Some light smoking is inevitable
and no reason for concern. Lift off the black plastic cover after every use and clean the area under it.
Also clean the pinhole in the oil container lid after each use. Keep the groove in the guide bar clean at
all times.
If the unit fails to oil the chain properly it may well be that the groove is full of saw dust and bark
shavings. Remove the chain and clean out the groove with a suitable tool or blow it out with
compressed air. To keep the unit at top performance the chain must be sharp.
If you notice that the unit's performance is not as it should be and the chain does not eat into the
wood by itself, the chain should be sharpened. Either use the saw chain sharpener or have the chain
sharpened by a professional. When the chain is ground down to the wear mark it should be replaced.
Saw chains are available from the Herstella in sets of two and one drive sprocket. The drive sprocket
should be changed after every second chain.
Page 45 de 64