Publicité
6 von 30
No.
Mat. no.
Designation
1
Coding plug MFM 53X
1
Plug N1Q_ST11A
1
Wiring harness N1-1, N1-16 L, N
1
Wiring harness N1-1, N1-16 Bus
1
Wiring harness N1-16_ST13, X3-4
1
Wiring harness N1-16_ST11, Y39
1
Connection wire, blue 0.75 x 280
2
Raised-head screws, M4 x 10
1
Intake valve 3/4"
1
Hose
2
Hose clips, 8 - 16 mm
1
Screw connector strip, 4-pole, neutral
1
Screw connector strip, 4-pole, red
1
Screw connector strip, 6-pole, blue
1
Screw connector strip, 7-pole, green
1
Terminal strip 1X3-4, orange / grey
1
Terminal strip 2X3-4, green / yellow
1
Accessory module
1
Wiring diagram
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
First read the Technical Service Documentation (TSD), then commence work.
Risk of injury due to sharp edges
CAUTION
There may be a risk of injury due to sharp edges.
Risk of injury due to sharp edges!
A
Protective gloves should be worn and the edge protection, Mat. no. 05057680, should be used.
Installing module 1 for liquid dispensing 1 - 6
A
Remove the machine lid, see the model-specific TSD.
A
Secure module (1) with holders (2) onto the cross support, see Fig. 1.
A
Fit terminal strips (3) in the pre-punched holes of the cross support, see Fig. 1.
A
Fix inlet valve (1) to the top of the back panel. To do this push the relevant embossed hole out of the top of the back
panel, see Fig. 2.
A
Fix cable screw connectors (2) to the top of the back panel. To do this push the relevant embossed holes out of the
top of the back panel, see Fig. 2.
A
Connect screw connector strip 4-pole, neutral to ST6 on the module, see Fig. 3.
A
Connect screw connector strip 7-pole, green to ST8 on the module, see Fig. 3.
16.03.2018
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 10717751
Publicité
