Circuit Priming - Gaggia UNICA Sup 035G Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Make sure the knob switch is on " "
position; if necessary, turn it to the
indicated position.
• To turn the machine on simply press the
"ON/OFF" button.
• The blinking icons shown in the picture
warn that the circuit must be primed.
Note: Before starting the
Blinking
machine for the first time,
and after long periods of inactivity,
prime the water circuit.
• 28 •
• 28 •

Circuit Priming

• To prime the water circuit, place a
container under the steam wand (Pan-
narello, if supplied);
• Turn the knob clockwise and set it to
the "
" position. The machine starts
the automatic priming of the circuit by
letting out a preset quantity of water
through the Pannarello.
Once the circuit has been primed, the
icon on the display - shown in the fi gure
- turns on and remains lit.
Steady on
Turn the knon counter-clockwise in the
" " position.
• The icons displayed blink slowly to
show that the machine is warming
up.
Blinking
slowly
When warm-up is complete, the
machine performs a rinse cycle of the
internal circuits.
During this phase, the icons displayed
Blinking
will blink in sequence.
• When the operations described above
are completed, the icons on the display
will illuminate.
Steady on
The machine is then ready to brew
beverages.
• To brew coff ee, dispense hot water or
steam, and for a proper use of the ma-
chine, carefully follow the instructions
provided.

Publicité

Table des Matières
loading

Table des Matières