Description Of Parts; Preparation; Circuit Priming; Instructions For The Power Supply Cord - Gaggia ESPRESSO DOSE Mode D'emploi

Description of parts:

FIG. 01
1 Main switch
2 Manual dispensing / hot water button
3 Steam button
4 Dose programming/Coffee dispensing button
5 Correct temperature light
6 Turbo frother steam nozzle (removeable)
7 Filterholder
8 Removable water tank
9 "Perfect crema" pod fi lter
10 "Perfect crema" fi lter for ground coffee
11 Basin (removable)
12 Frothing jet device
13 Brewing head
14 Filterholder gasket
15 Overfl owing protection hole
16 Shower disc
17 Tamper
18 Power cable and plug
19 Measuring spoon
20 Delivery spout
21 Tank cover
22 Grid (removable)
23 Cappuccino maker kit (OPTION)
24 Steam/hot water knob
Instructions for the power supply
cord
A A short power-supply cord is provided to reduce risks of
getting tangled up or tripping over a longer cord.
B Longer extension cords are available and may be used if
care is exercised in their use.
C If a long extension cord is used:
1 the marked electrical rating of the extension cord
should be at least as great as the electrical rating of
the appliance;
2 if the appliance is of the grounded type, the extension
cord should be a grounding type; if the power supply
cord has a polarized plug (one blade is wider than
the other), as a safety feature, this plug will fi t in a
polarized outlet only one way. If the plug does not
fi t fully in the outlet, reverse the plug. If it still does
not fi t, contact a qualifi ed electrician. Do not attempt
to defeat the safety feature;
3 the cable does not hang from the table to avoid the
risk of getting caught up in it.
4 If damaged, the power cord must be replaced by the
manufacturer or an authorised service centre.

Preparation:

1. Remove the water tank cover (21) and fi ll the tank with
cold water checking the level through the tank window
shown in FIG. 02.
N.B.: The upper section of the tank (8) is provided with an
overfl owing safety hole (15) in case of tank overfi lling.
The water tank can also be removed (FIG.02), after
removing the tank cover (21).
Re-install tank with water and cover.
2. Insert plug (18) into a suitable wall outlet (see point 1
under "Caution").
3. Push the main switch (1). The temperature light (5) will
fl ash until the temperature is reached; when the tempera-
ture is reached the light will remain on.

Circuit Priming

N.B.: Upon fi rst use, after dispensing steam or when the
water tank is empty, the machine's water circuit must
always be primed.
This machine, featuring a pump to brew coffee, is equipped
with a self-priming system.
Place an empty cup under the brewing head (13), do not
insert the fi lter holder and press the hot water/coffee switch
(2) ("1 Pos.).
You will hear the sound of the operating pump, and after
a few seconds, water will start fl owing out of the brewing
head (13).
Warning! Before removing the water tank,
make sure that the machine is off as not to
damage the self-primer.
• 11 •
ENGLISH