Troubleshooting; Installation - ZANKER EHE60000X Notice D'utilisation

Troubleshooting

Problem
You cannot activate the appliance or
operate it.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
A
MOD.
PROD.NO.
SER.NO
DATA
MODEL
A) Stick it on Guarantee Card and send this part (if ap-
plicable)
B) Stick it on Guarantee Card and keep this part (if ap-
plicable)

Installation

Warning! Refer to the Safety chapters.
Before the installation
14
Possible cause
Problem with the house electrical
system.
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
MODEL
Activate the appliance again and set
the heat setting in less than 10 sec-
onds.
Examine the fuse in the electrical
system of the house in the fuse box.
If the fuses blow again and again,
speak to qualified electrician.
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
Labels supplied with the accessories bag
Stick the adhesive labels as indicated below:
C
MOD.
PROD.NO.
0049 SER.NO.
C) Stick it on instruction booklet
Before the installation of the appliance, record the infor-
mation below from the rating plate. The rating plate is on
the bottom of the appliance casing.
• Model ...........................
• PNC .............................
Remedy
TYPE
230V-50Hz
IP20