Troubleshooting; Installation - ZANKER KEV6043FBB Notice D'utilisation

• Scratches or dark stains on the surface have no
effect on how the hob operates.
• Use a special cleaner applicable for the surface of
the hob.
• Use a special scraper for the glass.
Cleaning the hob
• Remove immediately: melted plastic, plastic foil,
sugar and food with sugar. If not, the dirt can cause
damage to the hob. Take care to avoid burns. Put

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate the
hob.
Residual heat indicator does not
come on.
There is a dark area on the
multiple zone.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Make sure, you
operated the hob correctly. If not the servicing by a

Installation

Warning! Refer to Safety chapters.
Hob and oven connection type
This appliance has an orange 1x14 pole connector and
can be connected to an oven with an orange 1x14 pole
connector.
14
the special scraper on the glass surface at an acute
angle and move the blade on the surface.
• Remove when the hob is sufficiently cool:
limescale rings, water rings, fat stains, shiny metallic
discoloration. Clean the hob with a moist cloth and
non-abrasive detergent. After cleaning, wipe the hob
dry with a soft cloth.
• Remove shiny metallic discoloration: use a
solution of water with vinegar and clean the glass
surface with a moist cloth.
Possible cause
The fuse is blown.
The zone is not hot because it op-
erated only for a short time.
It is normal that there is a dark area
on the multiple zone.
service technician or dealer will not be free of charge,
also during the warranty period. The instructions about
the Service Centre and conditions of guarantee are in
the guarantee booklet.
Before the installation
Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
Remedy
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.