HumanTechnik lisa Mode D'emploi page 10

Converter 1
lisa -> radio
Important: Converter 1 lisa -> radio :
"Transmit with delay" is pressed
Converter 1 lisa -> radio :
"Transmit with delay" is not pressed
Channel selection
A special digital transmission process
ensures that the radio signals are pik-
ked up without errors. This process
also makes it possible to set 10 diffe-
rent radio channels. When supplied
from the factory, all lisa devices are
set to channel 0. It is only necessary to
set units to other channels if you have
several different users operating units
in the same building.
Set the required channel by using a
small screwdriver to turn the channel
selector switch, which is located on
10 English
Maximum transmission range
the backside of the converter lisa ->
radio, to the required channel num-
ber.
All transmitters and receivers must
be set to the same channel.
Example: Set channel number 0
Converter 2
lisa -> radio