Starting Operation - Bosch PSR 10,8 LI Notice Originale

OBJ_BUCH-1400-002.book Page 32 Wednesday, July 4, 2012 7:49 AM
32 | English
Operation

Starting Operation

Reversing the rotational direction (see figure C)
The rotational direction switch 7 is used to reverse the rotational direction
of the machine. However, this is not possible with the On/Off switch 8 ac-
tuated.
Right Rotation: For drilling and driving in screws, push the rotational di-
rection switch 7 left to the stop.
The indicator for right rotation 4 lights up when the On/Off switch
8 is actuated and the motor is running.
Left Rotation: For loosening or unscrewing screws, push the rotational
direction switch 7 right to the stop.
The indicator for left rotation 6 lights up when the On/Off switch
8 is actuated and the motor is running.
Setting the torque
The required torque can be preselected in 20 steps with the torque prese-
lection ring 3. With the correct setting, the insert tool is stopped as soon
as the screw is screwed flush into the material or when the set torque is
reached.
Select a higher setting when driving out screws, or set to the symbol "Drill-
ing".
Switching On and Off
To start the machine, press the On/Off switch 8 and keep it pressed.
The power light 9 lights up when the On/Off switch 8 is slightly or com-
pletely pressed, and allows the work area to be illuminated when lighting
conditions are insufficient.
To switch off the machine, release the On/Off switch 8.
When not using the power tool, switch it off in order to save energy.
Adjusting the Speed
The speed of the switched on power tool can be variably adjusted,
depending on how far the On/Off switch 8 is pressed.
Light pressure on the On/Off switch 8 results in a low rotational speed.
Further pressure on the switch results in an increase in speed.
2 609 005 103 | (4.7.12) Bosch Power Tools