Bosch PSR 10,8 LI Notice Originale page 30

OBJ_BUCH-1400-002.book Page 30 Wednesday, July 4, 2012 7:49 AM
30 | English
Assembly
Battery Charging (see figure A)
Do not use other battery chargers. The supplied battery charger is
designed for the Lithium-Ion battery in your machine.
Observe the mains voltage! The voltage of the power supply must
correspond with the data given on the nameplate of the battery charg-
er. Battery chargers marked with 230 V can also be operated with
220 V.
Note: The battery is supplied partially charged. To ensure full capacity of
the battery, completely charge the battery in the battery charger before
using your power tool for the first time.
The Lithium-Ion battery can be charged at any time without reducing its
service life. Interrupting the charging procedure does not damage the bat-
tery.
The Lithium-Ion battery is protected against deep discharging by the
"Electronic Cell Protection (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective circuit: The inserted tool no
longer rotates.
Do not continue to press the On/Off switch after
WARNING
the machine has been automatically switched
off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this manner.
The charging procedure begins as soon as the mains plug of the battery
charger is plugged into a socket outlet and the charge connector 12 is
plugged into the socket 11 on the bottom of the handle.
The battery charge-control indicator 5 indicates the charging progress.
During the charging process, the indicator flashes green. When the bat-
tery charge-control indicator 5 lights up green continuously, the battery
is fully charged.
During the charging procedure, the handle of the machine warms up. This
is normal.
Disconnect the battery charger from the mains supply when not using it
for longer periods.
2 609 005 103 | (4.7.12) Bosch Power Tools