Troubleshooting The Mower - Briggs & Stratton 2691485-00 Manuel D'utilisation

Troubleshooting the Mower

PROBLEM
Mower cut is uneven.
Mower cut is rough
looking.
Engine stalls easily
with mower engaged.
Engine runs and tractor
drives, but mower will
not drive.
NOTE: For all other problems, contact an Authorized Service Dealer.
LOOK FOR
Tractor tires not properly
inflated.
Engine speed too slow.
Ground speed too fast.
Engine speed too slow.
Ground speed to fast.
Dirty or clogged air filter.
Cutting height set too low. Cut tall grass at maximum cutting height during first pass.
Engine not up to
operating temperature.
Starting mower in tall
grass.
PTO not engaged.
See Check Tire Pressure section.
Set to full throttle.
Slow down.
Set to full throttle.
Slow down.
See Servicing Air Filter section.
Run engine for several minutes to warm-up.
Start the mower in a cleared area.
Engage the PTO.
REMEDY
25