Loading The Nailer - Makita GN900 Manuel D'instruction

Installing the hook
1
► 1. Hook
The hook is convenient for hanging the tool temporarily.
The hook can be set in two positions according to where
the tool will be hung.
To change the hook position, contract it at its foot by
pushing in from both sides and shift to another position.
ASSEMBLY
CAUTION:
• Always remove the fuel cell and the battery
cartridge.

Loading the nailer

Insert a strip of nails into the slit in the rear of the
magazine.
Pull the Pusher Lever to the rear of the Magazine and
return it to the end of the strip gently.
Load nails so that they get parallel to the driver guide.
Removing nails
► 1. Pusher button
Pull the pusher lever and push the pusher button to
release the nail supporter, and then return the pusher
lever to the top pushing the pusher button.
Slide the nails toward the rear of the magazine and
remove them out.
8 ENGLISH
1