Unloading The Nailer; Connecting The Air Hose - Makita AN923 Manuel D'instruction

ASSEMBLY
CAUTION:
• Always lock the trigger and disconnect the hose
before carrying out any work on the tool.
Loading the nailer
Select nails suitable for your work. Insert strip of nails
into the magazine.
Load nails so that they get parallel to the driver guide.
► 1. Pusher
Pull the pusher lever to the rear to engage the pusher
to the last nail.

Unloading the nailer

► 1. Pusher lever 2. Depress 3. Return
Pull the pusher lever to the rear. Return the pusher
lever back while keeping the pusher depressed to dis-
engage it from the strip of nails.
Depress the nail stopper and remove the strip of nails
from the magazine.
► 1. Nail stopper

Connecting the air hose

1
1
► 1. Air socket 2. Air fitting
Lock the trigger. Slip the air socket of the air hose
onto the air fitting on the nailer. Be sure that the air
socket locks firmly into position when installed onto
the air fitting. A hose coupling must be installed on or
near the tool in such a way that the pressure reservoir
will discharge at the time the air supply coupling is
disconnected.
6 ENGLISH
1
3
2
1
2