lopital Tango XL Mode D'emploi page 26

Option: Comfort leg supports (Article number 6960 8026).
The comfort leg supports provide the legs with additional support. The comfort leg sup-
ports can be adjusted in length as well as according to the sitting angle. The angle of
the leg supports can be adjusted to 4 positions (See figure 5 to 8). To change the seating
angle, you have to release the locking pin. When you have determined the correct posi-
tion, lock the sitting angle of the comfort support once again (See figure 9).
Make sure that the locking pin slips in well into one of the 4 holes.
Figure 5 to 8 Adjustable seating angle.
Figure 9 Locking pins.
To adjust the length of the leg supports, you have to release the locking pin underneath
by loosen it a bit (See figure 9). Choose the right length for the leg support and tighten
the locking pin again.
Make sure that both the sitting angle and the length of the leg support are
locked properly as soon as they have to support a load.
Always place these parts on the seat as soon as you finish using them. This
prevents you from looking for the parts.
26 | Instructions for use | Tango XL Shower-toilet chair
Setting the angle of the locking pin
Setting the length of the locking pin