Maintenance And Servicing; Cleaning And Maintenance; Ordering Replacement Parts - EINHELL NHM 260/230 Mode D'emploi

Anleitung NHM 260-400-230_SPK1:Anleitung NMH 260-400-230_SPK1
GB
14. Changing the place of
installation (Fig. 49)
Lift the machine with the aid of the transportation
handles (11) until the transportation wheels (18) are
on the floor and can turn.

15. Maintenance and servicing

15.1 Replacing the planing knives (Fig. 36/44-46)
Always switch the machine off before starting
any maintenance work. To prevent workpieces
from being kicked back as a consequence of
blunt knives, check the sharpness of the knives
at regular intervals. Exchange blunt knives as
follows:
Remove the parallel stop as described in 11.1. Undo
the screws (a) on the latch (22). Screw the screws (a)
into the latch in a clockwise direction. Remove the
latch (22) from the knife block (23) together with the
knife (21). Clean the parts. Fasten a new knife (21) to
the latch (22) and fit back in the knife block. Tighten
the screws (a) lightly. Then check the amount by
which the knife (21) projects out of the planing table
(14). Use a dial gauge or ruler to do so.
The maximum amount by which the knife (21) is
permitted to project from the planing table (14) is
0.1 mm.
To correct the knife projection, screw the three Allen
screws (b) on the latch (22) further in and out. You
should also make sure that the knife projects by the
same amount across the length of the knife block (23)
(Fig. 46). Once the knife projection has been set
correctly, re-tighten the screws (a). Tighten the
screws (a) in the middle first, then the ones on the
outside.
Important!
Only use knives which have been produced
specifically for this machine. If you use other knives
there is a risk of injuries as a consequence of a lack of
control. Avoid over-tightening and the possibility of
the thread becoming detached. If the latch (22) or the
screws have worn out threads they must be
immediately replaced.
15.2 Belt tension (Fig. 47/48)
Check the belt tension after the first five hours of
operation of the machine. To do so, undo the wing
nuts (a) with which the belt cover (45) is fastened.
Check the tension by pressing the belt (46). The
amount of play should be 15-20 mm.
24
02.10.2006

15.3 Cleaning and maintenance

Clean dust off the drive gear unit of the
thicknessing plane with a brush or compressed air.
Lubricate all clamping points and chains at regular
intervals with a few drops of engine oil.
Keep the belt (46) free of oil and grease at the
same time, however.
Clean chips and dust off the spindles on the
thicknessing table at regular intervals and lubricate
them with a little oil. Keep the infeed table (13), the
planing table
(14) and the thicknessing table (42) free of chips.
Improve the smooth running of the tables by
applying lubricant at regular intervals.

15.4 Ordering replacement parts

Please provide the following information on
all orders for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
8:23 Uhr Seite 24