Loading Tool - Ryobi ONE+ AIRSTRIKE P318 Manuel D'utilisation

 Keep hands and body parts clear of immediate work
area. Hold workpiece with clamps when necessary to
keep hands and body out of potential harm. Be sure
the workpiece is properly secured before pressing the
fastener against the material.
 Keep face and body parts away from back of the tool
cap when working in restricted areas. Sudden recoil
can result in impact to the body, especially when nailing
into hard or dense material.
 During normal use the tool will recoil immediately
after driving a fastener. This is a normal function of
the tool. Do not attempt to prevent the recoil by holding
the nailer against the work. Restriction to the recoil can
result in a second fastener being driven from the nailer.
Grip the handle firmly, let the tool do the work and do not
place second hand on top of tool or near exhaust at any
time. Failure to heed this warning can result in serious
personal injury.
 Do not drive fasteners on top of other fasteners or with
the tool at an overly steep angle as this may cause
deflection of fasteners which could cause injury.
NAILER SAFETY WARNINGS
5 — English

LOADING TOOL

 Do not load the tool with fasteners when any one of
the operating controls is activated.
When loading tool:
 Never place a hand or any part of body in fastener
discharge area of tool.
 Never point tool at anyone.
 Do not pull the trigger as accidental actuation may
occur, possibly causing injury.
SAVE THESE INSTRUCTIONS
 Refer to them frequently and use them to instruct others
who may use this tool. If you loan someone this tool, loan
them these instructions also.