Setting The Temperature - Beurer HT 60 Mode D'emploi

> Turn the locking ring [10] fully anti-clockwise. The attachment is locked in place.
> Check that the attachment is firmly secured to the handle [6].

Setting the temperature

The sliding switch [5] allows you to choose between two temperature settings. We recommend the follow-
ing temperature setting depending on your hair type:
Setting Hair type
1: Low Fine, brittle, coloured or bleached hair
2: High Normal and strong hair
Note
• The higher the temperature selected, the faster you will achieve the desired result.
• Use the sliding switch [5] to select the required temperature setting.
• The multi-functional styler is ready to use in a few minutes.
Shaping your hair
Preparing your hair
> Dry your hair fully before using the multi-functional styler.
> Your hair should be clean and free of any styling products.
> Untangle your hair by combing it with a rough-toothed comb.
Forming curls/waves
You can shape your hair with the curling tongs [A, B, C]:
> Divide your hair into individual sections approximately 2 centimetres wide. Hold the section taut.
> Press on the curling tongs lever to open the clip piece.
> Place the hair section with the tips between the heating tube and the clip piece of the curling tongs.
> Close the clip piece to secure the hair.
> Wind the hair around the curling tongs towards your head.
> Leave the curling tongs in the hair for approximately 8 to 10 seconds. This will achieve the best results
without subjecting your hair to excess stress or damage.
> Open the clip piece and carefully pull the heating tube away from the curl.
Shaping ends
> Place the hair section with the tips between the heating tube and the clip piece of the curling tongs.
> Close the clip piece to secure the hair.
> To shape the ends, turn the curling tongs inwards or outwards before pulling the ends outwards.
17