Beurer HT 60 Mode D'emploi page 18

Using the brush attachment
You can use the brush attachment [E] with the curling
tongs [B]:
> Make sure that the curling tongs [B] are cool.
> With the notch facing upwards, carefully slide the
brush attachment [E] fully onto the cold curling
tongs [B].
> The clip piece must be closed in order to do this.
> Divide the hair into individual sections. Hold the
section taut.
> Wind the section of hair around the brush.
> Wait approximately 10 seconds before unwinding
the hair.
Using the spiral attachment
You can use the spiral attachment [D] with the curling
tongs [A]:
> Ensure that the curling tongs [A] are cool.
> Slide the spiral attachment [D] down to the middle of
the closed, cold curling tongs [A].
> Press on the curling tongs lever to open the clip
piece.
> Carefully slide the spiral attachment [D] fully onto the
cold curling tongs [A].
> Close the clip piece.
> Divide the hair into individual sections. Hold the
section taut.
> Press on the lever of the curling tongs [A] to open
the clip piece.
> Place the hair section with the tips between the
heating tube and the clip piece of the curling tongs
[A].
> Close the clip piece to secure the hair.
18