FLAEM NebulAIR+ Mode D'emploi page 16

AIR FILTERING
The device is quipped with an extraction filter (A3) that must
be replaced when it is dirty or changes colour. Do not wash or
reuse the same filter. Regular filter replacement is necessary to
help ensure proper compressor performance. The filter must be
checked regularly.
Contact your retailer or authorised service centre for
replacement filters.
To replace the filter:
Insert a slotted screwdriver between the edge of the filter and the body. Lift the filter and
extract it by rotating and pulling up. The filter was designed to always remain secured in its
seat. Use only with original Flaem accessories.
SYMBOLS
TUV approval ref. EN 60601-1 3rd Ed. - EN 60601-1-11
EC Marking medical ref. Dir 93/42
EEC and subsequent updates
Class II device
Attention: check the instructions
for use
Operating switch off
Operating switch on
In compliance with: European
Standard EN 10993-1 ''Biological
Evaluation of medical devices''
and European Directive 93/42/EEC
"Medical Devices."
Phthalate-free. In compliance with:
Reg. (EC) no. 1907/2006
Device serial number
Manufacturer
Type BF applied part
Alternating current
Risk: electrocution.
Consequence: Death.
Using the device while taking a bath
or shower is prohibited
Degree of protection of the casing:
IP21.
IP21
(Protected against solid foreign objects larger
than 12mm. Protected against access with a fin-
ger; Protected against vertically dripping water).
14